EVHelp
Fit & Clasp Guide
Every EVORYNN piece ends in the same EV clasp: a mirror-finish lobster clasp on a split ring. This guide shows where each piece goes, how it attaches and what it is made to carry.
The EV clasp
- Press the small lever on the lobster clasp with your fingertip; the clasp opens.
- Hook the open clasp over a ring, a loop or a phone tab cord.
- Release the lever until the clasp closes, then give the piece a light tug to check it is closed.
Two pieces can be joined: clip the clasp of one piece onto the split ring of the other. A drop charm clipped under a wrist loop, for example, makes one longer charm.
Phones: the phone tab
Phone charms and lanyards come with a clear phone tab. The tab is a thin flat piece with a cord loop that sits between your phone and its case, with the loop coming out at the charging port.
- Take your phone out of its case.
- Lay the tab flat on the back of the phone with the loop at the charging port.
- Put the case back on so it holds the tab in place.
- Clip the EV clasp onto the loop.
The tab works with most cases that have an opening at the charging port. It does not work without a case, or with cases that cover the port completely. If your case has its own lanyard hole, you can clip the clasp straight onto a cord through that hole instead.
Bags, keys and zips
Bag dangles and keyring clusters hang from a large chrome ring. Clip them to a bag handle, a strap ring, a zip pull, a belt loop or a key ring. Keep heavy keys on a separate ring so the beads don’t take the weight.
Earbud cases
Earbud case charms are sized for the small lanyard loop or ring found on many wireless earbud cases, or on a silicone earbud cover. If your case has no loop, you can use a cover that has one.
Glasses
Glasses chains have a small clear silicone loop at each end. Slide one loop over the end of each arm of your glasses and pull it snug about 2 cm from the tip. The chain opens at the EV clasp in the middle, so you can also wear half of it as a charm.
What each piece carries
| Piece | Length | Made to carry |
|---|---|---|
| Crossbody lanyard | about 120 cm | One phone in its case, clipped to the phone tab |
| Short lanyard | about 45 cm | One phone in its case, around the neck or doubled on the wrist |
| Wrist loop | 18 cm loop | Decoration. Slips over the wrist while you hold the phone |
| Drop, pixel strand, cluster charm | 11–16 cm | Decoration only |
| Bag dangle, keyring cluster | 10–14 cm | Decoration only |
| Glasses chain | about 70 cm | One pair of glasses around the neck |
| Earbud case charm | 8 cm | Decoration only |
Please note: none of our pieces is a safety strap. They do not stop a phone, bag, glasses or earbud case from falling and do not protect it if it falls. Do not swing a phone on a lanyard, and do not hang anything heavier than a phone in its case on it.
Care and safety
- Wipe with a soft, dry cloth. Keep away from water, perfume, sunscreen and cleaning products.
- Store pieces separately so chrome parts do not scratch the beads.
- Check clasps and rings now and then. If a ring opens or a bead cracks, stop using the piece and email us.
- Warning: small parts. Choking hazard. Not suitable for children under 3 years. Keep beads, rings and clasps away from small children and pets.
Still not sure? Ask us with a photo of your phone case, bag or earbud case, and we will tell you what fits.